Switchport Mode - SMC Networks 6726AL2 Management Manual

Example
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
Related Commands
shutdown (4-149)

switchport mode

This command configures the VLAN membership mode for a port. Use
the no form to restore the default.
Syntax
switchport mode {trunk | hybrid | private-vlan}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk
is a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. Note that frames belonging
to the port's default VLAN (i.e., associated with the PVID) are also
transmitted as tagged frames.
• hybrid - Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
• private-vlan - For an explanation of this command see "switchport
mode private-vlan" on page 4-213.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
VLAN C
OMMANDS
4-201