Boot System - SMC Networks 6726AL2 Management Manual

Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description of the
file information displayed by this command.
Console#whichboot
----------------------------
Unit1:
Diag_V2.2.1.3.bix
V2.2.2.2.bix
startup
------------------------------------------------------------------
Console#

boot system

This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (This is unit 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
file name
F
LASH
file type
-------------- ------- -----------
Boot-Rom image
Operation Code
Config File
Total free space:
/F C
ILE OMMANDS
startup size (byte)
Y 196020
Y 1745500
Y 6023
340787
4-93