Configuring The Control Port; Supervisory Port - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

COMSPHERE 6800 Series Nework Management System

Configuring the Control Port

To communicate with the 719 NETWORKER and through it to the NMS, you must first verify that
the control port on the 724/735 multiplexer is configured as a supervisory port with the correct
settings.

Supervisory Port

After the terminal or PC and the multiplexer are turned on, the following prompt appears:
To verify that the control port is configured as a supervisory port (to communicate with a 719
NETWORKER), perform the following steps:
1. Access the control mode of the multiplexer,
2. TYPE: the current password
3. TYPE: 1
4. TYPE: 2
5. TYPE: 4
2-22
Local: menus (y/n) >
TYPE: y
PRESS: Enter
The screen displays Local: Enter Password >
The default password is enter. The password does not appear on the screen.
PRESS: Enter
The Local/Remote Menu appears.
PRESS: Enter
to access the Local Menu. The Function menu appears.
PRESS: Enter
to access the Configuration menu. The Configuration menu appears.
PRESS: Enter
to access the System Configuration menu. The System Configuration menu appears.
August 1994 6800-A2-GB21-10