Connecting A Pc - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

To connect the ASCII terminal to the multiplexer, perform the following steps:
1. Connect one end of the cable to the modem port on the terminal.
2. Connect the other end of the cable to one of the NAPs on the multiplexer.
3. Turn on the terminal.
4. Turn on the multiplexer.
5. PRESS: Enter
6. Go to Configuring Network Administration Ports (NAPs) to continue the configuration

Connecting a PC

Instead of a terminal, you can connect a PC to configure the multiplexer(s) to communicate with
the NMS host computer. However, a terminal emulator must be run on a PC so that the PC can be
used as an ASCII terminal. Two emulator programs are suggested: a VT-100 terminal emulator
(the other selection under the SCX menu) and CTRM.
Make sure the following parameters are set on the PC:
You need an EIA RS-232 (DB-25) cable to connect the PC to the multiplexer(s).
To connect a PC to the multiplexer, perform the following steps:
1. Connect one end of the cable to the serial port on the PC.
2. Connect the other end of the cable to one of the NAPs on the multiplexer.
3. Turn on the PC and invoke the terminal emulator program.
6800-A2-GB21-10
The message connected and the prompt dial: appear on the terminal screen.
process.
VT-100 Emulator parameters
PARAMETER
Character Length
Stop Bits
Speed
Parity
Handshake
CTRM Emulator parameters (must be set in the ctrm.ini file)
PARAMETER
-s9600
-c8 8
-pn
-S1
August 1994
SETTING
8 bits
1
9600 bps
None
XON/XOFF
SETTING
Speed = 9600 bps
Character length = 8 bits
Parity = None
Stop Bit = 1
Configuring Multiplexers
2-7