Node Specification Dialog Window; Generating A Routing Table - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

COMSPHERE 6800 Series Nework Management System
3. Click on the selection area.
4. Click on the OK button.
5. Click on the Yes button.

Generating a Routing Table

Like the grt command, the MRT creates new routing tables from the NMS facility profiles, but,
unlike the grt command, the new routing table is not downloaded automatically to the specified
node. Rather, it is loaded into the MRT and entered into the Node Selection list. The source field
must be set to Ntwk prior to generating the routing table. Please refer to Selecting the Network as
the Source or Destination for a Function.
To generate a routing table, perform the following steps:
1. Select Generate from the Table pull-down menu.
2. You can specify which node to generate routing tables in two ways, generating for all
1-52
The I-bar appears in the selection area.
TYPE: the name of the file
A confirmation window appears indicating that the file does not exist and asking:
Do you want to create it?
The name of the routing table file and the current date as last edited appear in the Routing
Table Information Area.
The Node Specification dialog window appears (see Figure 1-5). This window asks for
which node or nodes to generate routing table(s).
Figure 1-5. Node Specification Dialog Window
nodes or for specific nodes. The default is all.
a. Click on the OK button to accept the default, all.
August 1994 6800-A2-GB21-10