Change Port Options (Chpo) - Paradyne COMSPHERE 6800 Series Command Reference Manual

Change Port Options (chpo)

(Disruptive)
Use the chpo command to change the options on one or more of the ports on a COMSPHERE
3400/4400 Series modem.
For most commands, NMS enables you to specify the destination for the command's results and
schedule its execution. If the last page of the input form cannot accommodate the Destination for
results and Schedule execution fields, an additional page is provided. For a complete description
of these fields, refer to Chapter 1, Introduction.
Access Level:
Abbreviation:
Restrictions:
Routine:
Schedule:
Related Commands: Change Options (cho)
Change Port Options Input Form
There are two or more pages for the Change Port Options input form.
Page 1
Page 1 enables you to specify the device for which the port options are to be changed.
This input form contains the following field:
Device (Required field)
6800-A2-GB31-20
Data Technician, Manager, System Administrator
chpo
Alternate: chportop
This command can be sent only to COMSPHERE devices with TDM or
MSD port cards.
Yes
Yes
Change Port Speed(s) (chpsp)
Display Options (dsop)
Display Port Options (dspo)
Display Port Speed(s) (dspsp)
Enter the device whose port options are to be changed. Standard addressing format
applies to the input. For information on device addressing, refer to Appendix D of the
COMSPHERE 6800 Series Network Management System User's/System Administrator's
Guide.
January 1997
2Modem/DSU Commands
2-63