Defining A Command Port Profile - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

2. TYPE: the number of one of the nodes in the network
3. TYPE: 1
4. The following prompt appears:
5. TYPE: the link number for the path to the specified node
6. To save the route,
7. Repeat Steps 1 through 6 to set the route for each node in the network.
8. Go to Defining an External Systems Port Profile.

Defining a Command Port Profile

This procedure configures a channel port on the 719 NETWORKER, so that it can properly
connect to the command port on the 6800 Series NMS.
To define a profile for a command channel port, use the procedures described in the Defining a
Profile for a Channel Port section. The parameters for the command profile in Step 6 should match
those shown below.
6800-A2-GB21-10
PRESS: Enter
The Network Routing Parameters menu appears.
PRESS: Enter
(Node 101) enter link number >
PRESS: Enter
The Network Routing Parameters menu appears again with the updated Route via Link
information.
TYPE: S
PRESS: Enter
PARAMETER
Channel Mode
Channel Code
Flow Control
XON/XOFF Chars
ENQ/ACK Pacing
Modem Controls
Echoplex
Flush on Break
High Priority
Slow Packetizing
Info Message
August 1994
SETTING
Asynchronous
9600, 8 data bits, 1 stop bit, None
CTS/DTR
Set 1: 11H/13H
Inactive
DCE (Local)
None
Active
Inactive
Inactive
Inactive
Configuring Multiplexers
2-39