Assigning A Profile To A Channel Port - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

COMSPHERE 6800 Series Nework Management System
6. If a parameter on your Profile Definition screen does not match those shown above, enter
7. TYPE: the number of the correct parameter
8. When all of the parameters are correct, save the options.
9. Go to Assigning a Profile to a Channel Port.

Assigning a Profile to a Channel Port

To assign a profile to a 719 NETWORKER channel port,
1. Note which NETWORKER channel port the terminal or PC you are working on is
2. From the Configuration menu,
2-32
The Profile Definition screen appears showing the default parameters and settings for the
specified profile definition. For the terminal or PC channel port, the settings on your screen
should match those shown below:
PARAMETER
Channel Mode
Channel Code
Flow Control
XON/XOFF Chars
ENQ/ACK Pacing
Modem Controls
Echoplex
Flush on Break
High Priority
Slow Packetizing
Info Messages
the option (parameter) number.
PRESS: Enter
The screen for that parameter appears.
PRESS: Enter
PRESS: S
PRESS: Enter
The system returns to the Channel Parameters menu.
connected to. Assign the profile to this channel.
TYPE: 1
PRESS: Enter
The Channel Parameters menu appears.
August 1994
SETTING
Asynchronous
9600, 8 data bits, 1 stop bit, None
XON/XOFF
Set 1: 11H/13H
Inactive
DCE (Local)
Remote
Active
Inactive
Inactive
Inactive
6800-A2-GB21-10