Table of Contents
Advertisement
Transition type
You can set the way in which the transition occurs.
You can select the following transition types.
Transition type
Description
Mix
The new image progressively
fades in over the current image.
The sum of the two image outputs
is maintained constant, and the
output of each is at 50% at the
mid-point of the transition.
NAM (non-additive
The current image and new image
mix)
are compared, and the image with
the higher luminance level is given
priority in the output. The output of
each is at 100% at the mid-point of
the transition.
Super mix
The current image output is held at
100%, and is mixed with the new
image. The output at the mid-point
of the transition can be 0% to
100%.
Preset color mix
A color matte (plain image) is
inserted during the transition,
where the current image is
switched to the new image in a
two-stage transition.
Wipe
The current image switches to the
new image using a wipe pattern.
DME wipe
The current image switches to the
new image using a DME wipe
pattern.
Clip transition
Plays back frame memory video
content linked to a mix or wipe
transition.
Cut
The current image switches
instantaneously to the new image.
Basic Operation for
Transitions
The basic transition operation flow is as follows.
1
Select a background image using the background A
bus cross-point buttons in the cross-point control
block.
2
Select the switch target of a transition.
Select a next transition using the next transition
selection buttons in the transition control block.
For details about next transitions, see "Next
Transitions" (page 99).
3
Set the state for after the transition executes.
When switching the background, select a background
image using the background B bus cross-point
buttons.
For details about selecting a signal, see "Chapter 4
Selecting Signals" (page 84).
When inserting a key, set the key to insert.
For details about setting keys, see "Chapter 6 Keys"
(page 119).
When changing the key overlay sequence, set the key
priority.
For details about key priority, see "Key Priority"
(page 100).
4
Select a transition type.
Select a transition type using the transition type
selection buttons in the transition control block.
To switch (cut) from the current image
instantaneously to the new image, proceed to step 6.
For details about transition types, see "Transition
Type" (page 102).
5
Set the transition type.
Make the required settings for the selected transition
type.
• Transition rate settings (see page 104)
• Super mix settings (see page 103)
• Preset color mix settings (see page 103)
• Wipe settings (see page 152)
• DME wipe settings (see page 168)
• Clip transition settings (see page 176)
Using transition preview mode, you can check the
execution of the transition.
98
Advertisement
Table of Contents
