Table of Contents
Advertisement
To delete the entered value
Press the [CLR] button.
Note
You can also enter a difference value from the
currently set value using the [TRIM] button.
For details, see "Entering a difference from a current
value" (page 81).
4
Press the [ENTER] button.
The entry is applied and the set value is reflected on
the memory recall button in the utility/shotbox
control block.
Setting the independent key transition
rate (menu)
This section describes the M/E-1 key 1 menu as an
example.
1
Open the Home > M/E-1 > Key1 > Transition >
Transition Type menu (11101.51).
2
Select a transition type in the [Transition Type]
group.
When an operation mode that supports configuration
of transitions where keys are inserted/removed
independently is set, select a transition type for key
insertion in the [ON Transition Type] group and a
transition type for key removal in the [OFF Transition
Type] group.
3
Set the transition rate using the following parameter.
No.
Parameter
1
Transition Rate
Note
When a cut is selected as the transition type, it is not
possible to set the transition rate.
To set the transition rate in list view
You can set the transition rate in transition rate list view
on each switcher bank.
1
Open the Home > Utility > Transition Rate menu
(18201.21).
The transition rate for common transitions and
independent key transitions is displayed for each
switcher bank.
2
Select the target switcher bank to set.
Adjustment
Transition rate
3
Press the [Edit] button.
The transition rate setup window appears.
4
Press a [Key1] to [Key8] button and enter a transition
rate in the numeric keypad window.
When an operation mode that supports configuration
of transitions where keys are inserted/removed
independently is set, select a transition type for key
insertion using a [Key1] to [Key8] button in [Key On]
and a transition type for key removal using a [Key1]
to [Key8] button in [Key Off].
5
Press [OK].
Checking the independent key transition
rate setting
On the ICP-X7000, you can check the transition rate on
the display in the independent key transition execution
section of the transition control block, display in the
independent key transition control block, or display in the
key fader control block.
Executing an Independent Key
Transition
An independent key transition can be executed using the
transition control block, independent key transition
control block, key fader control block, or the menu.
Notes
• In the simple-type transition control block, an
independent key transition cannot be executed.
• In an independent key transition, the pattern limit
function is not available.
115
Advertisement
Table of Contents
