Table of Contents
Advertisement
3
Press the [Select Source] button.
A source selection window appears.
4
Switch the source using the source selection buttons.
Select a tab to change the button number to display.
Setting a source selection button to the on state
switches the source.
Router Operations (AUX Bus
Control Block)
Press the [RTR MODE] button on the cross-point pad in
the AUX bus control block, turning it on, to switch to
router operation mode.
You can select destinations and sources and perform
other operations using the AUX bus control block in
router operation mode.
For details about assigning destinations, sources, and
levels, see "Setting a Router" (page 421).
Selecting a destination and source
Select a destination using the 1st row and 2nd delegation
buttons in the AUX bus control block (router operation
mode) and select a source using the 3rd row and 4th row
cross-point buttons.
The delegation button rows/cross-point button rows may
have different operation modes depending on whether
second delegation mode is enabled/disabled.
The delegation button row/cross-point button row
operations are the same as on the AUX bus control block
(AUX bus operation mode).
For details, see "Operation Mode of a Button Row"
(page 90) and "AUX bus control block" (page 93).
Note
The operation mode of the [SHIFT] button in delegation
button rows/cross-point button rows in the AUX bus
control block (router operation mode) is set in the Home
> Setup > Panel > Router > Delegation Button Assign
menu (19104.51) and Home > Setup > Panel > Router >
Source Table Assign menu (19104.52).
For details about setting delegation button rows, see
"Setting the operation mode of the shift button"
(page 421).
For details about setting cross-point button rows, see
"Setting the operation mode of the shift button"
(page 422).
Selecting a level
Select using the [LEVEL BTN1] button to [LEVEL
BTN4] button assigned to the cross-point pad.
233
Advertisement
Table of Contents
