Table of Contents
Advertisement
ICP-X7000 transition control block (simple type)
TAKE button
Transition indicator
ICP-X1000 series transition control block
Transition indicator
CUT button
AUTO TRANS button
There are two modes for carrying out a transition: auto
transitions are carried out by a button operation, and
manual transitions are carried out using the fader lever.
It is also possible to combine both methods, taking
control with the fader lever of an auto transition which has
Fader lever
Fader lever
partly completed, or completing a transition started with
the fader lever as an auto transition.
Transition indicator
You can check the transition execution status using the
transition indicator on the transition control block/
transition control block (simple type).
The transition indicator displays the transition execution
status by which LEDs are lit and which are not, both for
manual transitions and auto transitions.
When the transition indicator is lit up to the center point,
the transition progress has reached 50%.
When the transition is completed, the transition indicator
turns off.
Auto Transitions
To switch images with the preset transition type
and transition rate
Press the [AUTO TRANS] button in the transition control
block or the [TAKE] button in the transition control block
(simple type).
The transition is executed automatically with the preset
speed (transition rate).
During the transition execution, the [AUTO TRANS]
button/[TAKE] button is lit amber.
To switch images instantaneously
Press the [CUT] button in the transition control block/
transition control block (simple type).
When the next transition is a key, the key is inserted or
removed instantaneously.
To complete a partially executed transition
instantaneously
Press the [CUT] button in the transition control block/
transition control block (simple type).
The [AUTO TRANS] button/[TAKE] button turns off.
Changing from auto transition to manual
transition
During an auto transition started by pressing the [AUTO
TRANS] button/[TAKE] button, operating the fader lever
immediately enables the fader lever, and the [AUTO
TRANS] button/[TAKE] button turns off. Thereafter, the
fader lever controls the execution of the transition.
Executing an auto transition using the
menu
This section describes the M/E-1 menu as an example.
1
Open the Home > M/E-1 > Bus/Transition > Wipe >
Wipe Snapshot menu (11109.37) or Home > M/E-1 >
Bus/Transition > DME Wipe > DME Wipe Snapshot
menu (11109.46).
106
Advertisement
Table of Contents
