Table of Contents
Advertisement
4
Press the [Edit] button.
The [Assign V/K Pair] window appears.
5
Set the button for the link destination logical V/K pair
number to the on state.
Select a tab to change the logical V/K pair number to
display.
6
Press [OK].
To return a link table to the initial settings
Press the [Initialize Table] button, check the message,
then press [OK].
Setting an M/E Link
You can link the transition operations between switcher
banks.
The following operations are linked.
• Transition execution (auto transition, cut, and fader
lever operation)
• Next transition selection
• Transition type selection
1
Open the Home > Setup > Link > M/E Link menu
(19107.21).
2
Select the target link number to set.
To select and set multiple link numbers, place a check
mark beside the target link numbers to set.
To select and set all link numbers, place a check mark
in the Select All checkbox.
3
Enable/disable the link using the [Link Enable]
switch.
On: Enable link.
Off: Disable link.
4
Press the [Controlling M/E] button and select a link
source switcher bank from the pull-down list.
5
Press the [Linked M/E] button and select a link
destination switcher bank from the pull-down list.
6
Select the operations to link using the [Transition
Only] switch.
On: Link transition execution only.
Off: Link transition execution, next transition
selection, and transition type selection.
448
Advertisement
Table of Contents
