Table of Contents
Advertisement
System signal format
2160P
1080P, 1080i, 720P
For details about the relationship between slots and input/output port numbers, see "Input/Output Numbers"
(page 511).
Note
On M/E-IP type boxes, audio output is supported only for input/outputs on ports 1 and multiples of 4 + 1 (1, 5, 9, and
so on).
For details about box types, see "Displaying Box Information" (page 369).
Recalling Video
1
Open the Home > Frame Memory > FM1/FM2 >
Clip/Still > Recall menu (13101.11).
Content can be displayed in list view or thumbnail
view.
The frame memory output channels are shown on the
left.
To enable group mode
Set the [Group Mode] button to the on state.
When group mode is enabled, the frame memory
output channel display changes to [FM1/FM2].
2
Select [FM1].
3
Select content to recall.
The selected content is recalled and displayed on the
frame memory output channel.
Note
When group mode is disabled for frame memory
output channels and combined content is selected,
only content 1 of the combined content is recalled on
frame memory output channel 1.
Output conditions
• When signals on ports on slot 1 are selected on the frame memory source bus and recorded,
and the frame memory assigned to No. 7 to 12 using the Home > Setup > Switcher > Box
Settings > Re-Entry Source Assign menu (19103.52) is output or the frame memory for slot 4
dedicated outputs is output
• When signals on ports on slot 4 are selected on the frame memory source bus and recorded,
and the frame memory assigned to No. 1 to 6 using the Home > Setup > Switcher > Box
Settings > Re-Entry Source Assign menu (19103.52) is output or the frame memory for slot 1
dedicated outputs is output
• When signals on ports on slot 1 are selected on the frame memory source bus and recorded,
and the frame memory assigned to No. 13 to 24 using the Home > Setup > Switcher > Box
Settings > Re-Entry Source Assign menu (19103.52) is output or the frame memory for slot 4
dedicated outputs is output
• When signals on ports on slot 4 are selected on the frame memory source bus and recorded,
and the frame memory assigned to No. 1 to 12 using the Home > Setup > Switcher > Box
Settings > Re-Entry Source Assign menu (19103.52) is output or the frame memory for slot 1
dedicated outputs is output
Playing Video
Playback of video content recalled on a frame memory
output channel can be controlled using the menu or device
control block.
Notes
• Playback of all video content (MOV files, MP4 files) is
not guaranteed.
• Before using video content on-air, always play the
content from start to finish to confirm it can be played
back correctly.
• Before checking the playback, save a backup of
important video content on a computer or on external
media connected to a computer.
Playing video (menu)
1
Open the Home > Frame Memory > FM1/FM2 >
Clip/Still > Play menu (13101.12).
When group mode is enabled, the frame memory
output channel display changes to [FM1/FM2].
2
Control the video using the operation buttons for
[FM1].
187
Advertisement
Table of Contents
