Table of Contents
Advertisement
Changes to the setting of a parameter in the analog
controls section are applied only to the item selected as
the target, even if multiple items are selected. Also, you
may not be able to change other settings simultaneously.
Setting Parameters
Pressing a parameter setting button displays an analog
controls section on the right side of the menu display area
for adjusting parameters.
Parameter 1 to 5 buttons
Analog controls section
This section is comprised by a parameter display button
and up to five parameter buttons (numbered 1 to 5 from
the top).
The target button name/group name to set is displayed on
the parameter display button. If there are six or more
parameters, a page number ("1/2" or "2/2") is displayed
on the parameter display button, and pressing the button
switches between page 1 and page 2.
The parameter name and current setting value are
displayed on each of the parameter 1 to 5 buttons.
Pressing a parameter button displays an analog controls
window for setting parameters.
In this manual, parameter setting operations are
represented by the parameter button number and
parameter name.
For parameters on two pages, the number is in "page
number - parameter button number" format.
Example:
Parameters on one page only
No.
Parameter
Adjustment
1
Width
Width
2
Position
Position
3
Density
Density
Parameter display button
Parameters on two pages
No.
Parameter
1-1
Top
1-2
Left
1-3
Right
1-4
Bottom
2-1
H Phase
2-2
V Phase
When using a mouse
You can click a parameter button and set the parameter
using the following operations.
• Adjust the set value by moving the mouse wheel up/
down.
• Adjust the set value by dragging the bar slider on the
right side of the parameter button up/down.
Analog controls window
The analog controls window displays a numeric keypad
on left side and a parameter adjustment area on the right
side.
Numeric keypad area
Guide display button
A guide window is displayed at the same time as the
analog controls window which describes the operation
method of the parameter adjustment area. To close the
guide window, press [OK]. If you place a check mark in
[Don't show this message again.], the guide window will
not be displayed.
Note
You can display the guide window by pressing the guide
display button.
77
Adjustment
Position of top edge
Position of left edge
Position of right edge
Position of bottom edge
Horizontal position
Vertical position
Parameter adjustment area
Default recall button
Advertisement
Table of Contents
