Table of Contents
Advertisement
To make a wipe pattern like a window blind
(Pairing)
Set the [Pairing] button to the on state and set the
following parameter.
No.
Parameter
Adjustment
1
Width
Width
To add modulation to a pattern (Modulation)
In the [Modulation] group, select a modulation type.
H: Modulate a pattern in the horizontal direction.
V: Modulate a pattern in the vertical direction.
The modulation is set to a sine wave.
Set the following parameters.
No.
Parameter
Adjustment
1
Amplitude
Amplitude of modulation
2
Frequency
Frequency of modulation
3
Speed
Speed of ripples
• Negative values create waves
• Positive values create waves in
in the down, left, and
counterclockwise directions.
the up, right, and clockwise
directions.
Image Effect
Overview
Image effect is a function used to apply a DME effect to
the signal selected on the background A bus or B bus for
output.
Notes
• Setting the image effect function introduces a one-
frame delay in the image.
• In flip-flop mode, interchanging the background A bus
and B bus signals also interchanges their image effect
settings at the same time.
DME restrictions
• To use the DME function, the MZS-X1610 3D DME
License (option) is required for each target box.
• When the system signal format is 2160P, the DME
function must be enabled for use.
For details about setting GPU functions, see "Setting a
GPU" (page 366).
• The number of DME channels that can be used will
vary, depending on the system signal format and the
DME enhanced function mode setting.
For details, see "DME channels" (page 197).
• The image effect function cannot be set when a
background DME wipe is set.
Number of DME channels that can be used
simultaneously
DMEs can be used in up to two locations simultaneously
on a single switcher bank (processed key or image effect).
The number of DME channels that can be used on a key
depends on the image effect use, as given below.
When not using the image effect function:
One DME channel on each of two keys, or one to four
DME channels on a single key can be used.
When using the image effect function on background A or
B:
One DME channel on a single key only can be used.
When using the image effect function on both
background A and B:
DMEs cannot be used on keys.
Notes
• In multi program 2 mode, DMEs can be used in up to
two locations (main and sub).
• When M/E split is enabled, one DME channel can be
used on each of the two sub blocks.
248
Advertisement
Table of Contents
