Table of Contents
Advertisement
Key Fill and Key Source
Selecting Signals (Menu)
Set the signals to insert in the key fill and key source.
This section describes the M/E-1 key 1 menu as an
example.
Setting a key fill/key source
1
Open the Home > M/E-1 > Key1 > Type > Type
Select menu (11101.11).
2
In the [Key Fill] group, set the key fill signal.
Key Bus: Key 1 bus signal
For details about selecting a signal, see "Selecting a
Key Fill Signal/Key Source Signal" (page 94).
Matte: Color matte
When the [Matte] button is selected, set the following
parameters.
No.
Parameter
1
Luminance
2
Saturation
3
Hue
3
In the [Key Source] group, set the key source signal.
Self: Self mode
Select the same signal as the key fill bus.
Auto Select: Auto Select mode
Select the signal assigned in pair with the key fill
bus signal.
Split: Split mode
Select a different signal than the key fill bus pair
signal.
When the [Split] button is selected, select a key
source signal.
For details about selecting a signal, see "Selecting a
Key Fill Signal/Key Source Signal" (page 94) and
"Selecting a Video Signal/Key Signal" (page 95).
Setting a key fill color mix
To mix color 1 and color 2 color mattes
When color matte is selected for a key fill, you can use a
wipe pattern or dedicated pattern to mix color 1 and color
2.
1
Open the Home > M/E-1 > Key1 > Type > Matte
Adjust menu (11101.13).
Adjustment
Luminance
Saturation
Hue
2
Set the [Mix Color] button in the [Fill Matte] group to
the on state and set the following parameters.
No.
Parameter
1
Size
2
Soft
To set a single color, set the [Flat Color] button to the
on state.
Note
The [Flat Color] button parameters are shared with
the [Matte] button parameters in the [Key Fill] group
in the Home > M/E-1 > Key1 > Type > Type Select
menu (11101.11).
3
In the [Mix Pattern] group, select a mix pattern for the
color mix.
Key Wipe: Use a wipe pattern selected for an
independent key transition.
Key Edge Pattern: Use a dedicated pattern.
When the [Key Edge Pattern] button is selected, press
the [Pattern Select] button. In the pattern selection
window, set the button for the target pattern to the on
state and press [OK].
Note
Dedicated patterns 1 to 24 are the same as standard
wipe patterns 1 to 24.
4
Press the [Color 1] button and set color 1 using the
following parameters.
No.
Parameter
1
Luminance
2
Saturation
3
Hue
Note
The [Color 1] button parameters are shared with the
[Matte] button parameters in the [Key Fill] group in
the Home > M/E-1 > Key1 > Type > Type Select
menu (11101.11).
5
Press the [Color 2] button and set color 2 using the
following parameters.
No.
Parameter
1
Luminance
2
Saturation
3
Hue
128
Adjustment
Pattern size
Softness of the pattern
contour
Adjustment
Luminance
Saturation
Hue
Adjustment
Luminance
Saturation
Hue
Advertisement
Table of Contents
