Table of Contents
Advertisement
For a Flexi Pad control block, transition control
block, transition control block (simple type),
independent key transition control block
Select the target switcher bank to set.
In the [Select Bank] group, place a check mark for the
switcher bank to select.
By default, the switcher bank where the selected
control block is located in the full view is selected.
You can also select multiple switcher banks and set
assignable buttons simultaneously.
Notes
• When multiple switcher banks are selected, the last
selected switcher bank becomes the reference and
is displayed highlighted. The button names
configured on the reference switcher bank are
displayed on the assignable buttons.
When the reference switcher bank is deselected, the
reference will be set according to the following
order of priority.
M/E-1 > M/E-2 > M/E-3 > M/E-4 > M/E-5 > P/P
• In multi program 2 mode, main and sub can be set
separately. When a switcher bank is set to shared
main and sub, the assignable button assignments
are also shared.
3
Press the target assignable button to set.
The [Select Function] window appears.
The functions that can be assigned to the selected
button are displayed in the [Select Function] window.
For Flexi Pad control block
Select a tab to change the function to display.
[Mode / Others] tab: Mode selection button/
operation button
[Bank] tab: Bank selection buttons
For an independent key transition control block
Select a tab to change the function to display.
[Current] tab: Keys of the switcher bank where the
selected control block is located
[Other banks] tab: Keys of the switcher banks other
than the switcher bank where the selected control
block is located
4
Set the button for the function to assign to the on
state.
To release a function assignment
Set the [No Assign] button to the on state.
5
Press [OK].
To set the fader lever in a key fader control block
You can set the key which is the target of fader lever
operation.
Press the button at the bottom of the fader lever to display
the [Select Function] window.
Set the button for the target key to the on state and press
[OK].
All: Enable operation for all four keys assigned to key
delegation buttons.
Disable: Disable fader lever operation.
Key delegation 1: Enable operation for the key assigned
to key delegation button 1.
Key delegation 2: Enable operation for the key assigned
to key delegation button 2.
Key delegation 3: Enable operation for the key assigned
to key delegation button 3.
Key delegation 4: Enable operation for the key assigned
to key delegation button 4.
Note
The name of the keys assigned to the key delegation
buttons are displayed for key delegation 1 to 4 above.
To return assignable button assignments to the
defaults
Press the [Default Recall] button, check the message, then
press [OK].
The assignable button assignments and fader lever
settings return to the defaults.
Assigning regions to a region selection
button in the numeric keypad control
block
You can assign up to four regions to each region selection
button.
When multiple regions are assigned, the region name set
for the lowest number is displayed on the region selection
button.
1
Open the Home > Setup > Panel > Module > Button
Assign menu (19104.21).
2
Press within the white frame of the target numeric
keypad control block to set.
An enlarged image of the numeric keypad control
block appears.
3
Press the target assignable button to set.
The [Select Function] window for selecting a region
number appears.
4
Press the [Edit] button for the target region number (1
to 4) to set.
The [Select Function] window for selecting a region
appears.
Select a tab to change the region to display.
[ME/DME] tab: Switcher bank and DME regions
[Dev/Macro] tab: External device and macro regions
[User] tab: User regions
409
Advertisement
Table of Contents
