Table of Contents
Advertisement
Manager Home > System > Island. Check the error
description to resolve the error, then press the [Detect/
Refresh] button in the MLS Manager Home > System >
Island > Detect Device menu (60211.01) to run device
detection again.
Displaying device properties
Select a box or control panel bank in the list and press the
properties display on/off button at the top right of the
screen to display the properties of the selected box or
control panel bank on the right side.
Recovering from mismatches
If there is a mismatch between the obtained configuration
information from a detected device and the configuration
information managed by MLS Manager, an error will be
displayed. Press the [Recover Mismatch] button to
recover from mismatches.
Configuring an Island
You can assign M/E boxes and cross-point boxes to an
island and check the local interface connections between
the assigned boxes.
Note
Do not perform a connection check during normal system
operation.
1
Open the MLS Manager Home > System > Island >
Island Config menu (60211.02).
2
In the list on the left, select an assignment destination
physical box ID.
3
In the list on the right, select a box to assign to the
island.
4
Press the [Assign] button.
To release a box assignment
Press the [Release] button to release the box
assignment for the selected physical box ID.
5
Press the [Check Local I/F] button.
The [Check Local I/F] window appears.
6
Press the [Check Now] button.
A check of the local interface connections between
the assigned M/E boxes and cross-point box is
performed.
7
View the check results.
Port Status
Displays the wiring check results and connection
destination port information.
(OK icon): Wiring check results are consistent
(Error icon): Wiring check results are
inconsistent
(Error icon) + "(Not Exist)": Unable to check
wiring because there is no module on the port
(Error icon) + "(No Connection)": Unable to
check wiring because there is no module on the
port or because unable to obtain wiring check
results
Signal Status
Displays the signal quality check results.
(OK icon): Signal quality check results are OK
(Error icon): Signal quality check results
indicate an error
(Error icon) + "(Not Exist)": Unable to check
signal quality because there is no module on the
port or because unable to obtain signal quality
check results
Note
If an error occurs, check the box wiring and then press
the [Check Now] button again to execute a
connection check.
To sort the box list display
You can press a display item title in the list on the right to
sort the display. Pressing a title switches between
ascending and descending order each time you press the
title, and [v] (ascending) or [V] (descending) is displayed
on the right side of the title.
Type-I/O: Sort by box input/output type
Hostname: Sort by box host name
Setting the Island Format
You can set the system frequency, reference signal
format, and cross-point box signal format of an island.
Note
In a 1M/E box switcher configuration, set using the Home
> Setup > System > Format/Config > Format menu
(19101.22) on each switcher.
For details about settings, see "Setting the Signal Format
and Frequency" (page 367).
Setting the system frequency
You can set the system frequency of a switcher
configured from multiple boxes in an island.
476
Advertisement
Table of Contents
