Table of Contents
Advertisement
Configuring NMOS
You can configure the settings required for the ST 2110
routing function of the NMOS controller. The configure
procedure changes depending on whether the NMOS
system has RDS (Registration and Discovery System),
which is a device registration service.
Notes
• When the protocol is set to NDCP(LSM), NMOS
cannot be configured.
• If no MKS-X1110 IP Input & Output Boards are
installed in the cross-point box or an M/E box
configured in a switcher, the menu will not be
displayed.
Setting the Network Interface
You can set the network interface used for
communication with the NMOS controller.
1
Open the Home > Setup > 100G IP I/F > Controller >
NMOS menu (19108.13).
2
In the [Network Interface] group, select the interface
to use from the pull-down list.
Util LAN1
Util LAN2
Util LAN1&2
Util LAN bonding
Media LAN1
Media LAN2
Media LAN1&2
Note
When a Util LAN is selected, it must match the Util
LAN redundancy setting configured using MLS
Manager.
3
Press the [IS-04 Node Port] button and set the
listening port number of the switcher for NMOS
Discovery and Registration Specification (IS-04)
using the numeric keypad.
4
Press the [IS-05 Conn. Port] button and set the
listening port number of the switcher for NMOS
Device Connection Management Specification
(IS-05) using the numeric keypad.
5
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
6
Check the message, then press [OK].
Setting the Connection for an
NMOS System With RDS
1
Open the Home > Setup > 100G IP I/F > Controller >
NMOS menu (19108.13).
2
Enable/disable the RDS auto discovery function
using the [RDS Discovery] button.
3
In the [Primary RDS] group, press the [IP Address]
button and enter an IP address using the keyboard.
4
In the [Primary RDS] group, press the [Port] button
and enter a port number using the numeric keypad.
5
In the [Secondary RDS] group, press the [IP Address]
button and enter an IP address using the keyboard.
6
In the [Secondary RDS] group, press the [Port] button
and enter a port number using the numeric keypad.
7
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
8
Check the message, then press [OK].
To use the RDS auto discovery function
When the RDS auto discovery function is enabled using
the [RDS Discovery] button, either the uDNS or mDNS
auto discover function operates depending on the
situation.
uDNS
This function automatically detects an RDS using the
DNS function.
• Configuration example 1
1.Enable DHCP on the utility LAN in the MLS menu
beforehand.
2.In the [Network Interface] group, select [Util LAN]
from the pull-down list.
3.Select the [DHCP] button in the [DNS] group.
4.DNS information is obtained from the DHCP server
and RDS information is obtained from the DNS
server.
• Configuration example 2
1.Select the [Manual] button in the [DNS] group.
2.Set appropriate values for [IP Address] and [Service
Domain Name] in the [DNS] group.
3.RDS information is obtained from the DNS server.
453
Advertisement
Table of Contents
