Table of Contents
Advertisement
Setting a Source Signal
Name
You can set the name of a source signal.
1
Open the Home > Setup > System > Source > Edit
Source Name menu (19101.71)
2
Select the target source signal to set.
To select and set multiple source signals, place a
check mark beside the target source signals to set.
To select and set all source signals, place a check
mark in the Select All checkbox.
3
Press the [Source Name] button and enter a source
name (up to 16 characters) using the keyboard.
Note
When multiple source signals are selected,
consecutively numbered source names are set.
For details, see "Name settings when multiple items
are selected" (page 81).
Enabling/Disabling an
SDI Output Connector
You can enable or disable the signal output for an SDI
output connector.
When disabled, no signal is output from the output
connector.
Note
To prevent radio wave interference from occurring,
disable output connectors that do not have a cable
connected.
1
Open the Home > Setup > System > SDI Output
Enable menu (19101.91).
Buttons for the output connectors for boards installed
in each slot are displayed.
2
Select a tab (Logical Box ID 1 to Logical Box ID 5)
to switch the target to set.
Note
This cannot be set if MKS-X1115 SDI Input &
Output Boards are not installed.
3
Enable/disable using the button for the target output
connector to set.
On: Enable signal output.
Off: Disable signal output.
To enable all output connectors
Press the [All Enable] button.
4
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
5
Check the message, then press [OK].
385
Advertisement
Table of Contents
