Table of Contents
Advertisement
Setting 100G IP Input/
Output Signals
Note
If no MKS-X1110 IP Input & Output Boards are installed
in the cross-point box or an M/E box configured in a
switcher, the menu will not be displayed.
Setting an ST 2110 Stream
You can set whether to send redundant ST 2110 streams
(input/output).
1
Open the Home > Setup > System > 100G IP Input/
Output > Config menu (19101.52).
2
Enable/disable using the [Hitless Failover] button.
On: Send redundant ST 2110 streams (input/output).
Off: Do not send redundant ST 2110 streams (input/
output).
3
Press the [Apply] button.
To return to the previous setting
Press the [Clear] button.
4
Check the message, then press [OK].
Setting Multicasting
You can configure multicasting for each output of boxes
configured in a switcher.
For details about output numbers, see "Input/Output
Numbers" (page 511).
Notes
Cannot be configured in the following cases.
• When [NDCP(LSM)] is configured in the [Protocol]
group in the Home > Setup > 100G IP I/F > Controller
> Protocol menu (19108.21)
• When [NMOS] is configured in the Setup > 100G IP
I/F > Controller > Protocol menu (19108.21) and [Stop]
is configured in the [Device Connection Mgmt (IS-05)
Start Up Mode] group in the Home > Setup > 100G IP
I/F > Controller > NMOS menu (19108.22)
1
Open the Home > Setup > System > 100G IP Input/
Output > Output Multicast menu (19101.54).
2
Select a tab to switch the target to set.
[Video] tab: Change video settings
[Audio] tab: Change audio settings
[Meta] tab: Change metastream settings
Note
Audio and metastreams can be configured only for
ports 1 and multiples of 4 + 1 (1, 5, 9, and so on).
3
Select the target button to set.
To select and set multiple buttons, place a check mark
beside the target buttons to set.
To select and set all buttons, place a check mark in the
Select All checkbox.
You can also press the [Select Number(s)] button and
enter a number in the numeric keypad window.
The video stream (ST 2110) transmission status and
output name are displayed in [Strm Sts./Name].
To sort the multicast list display
You can press a display item title to sort the display.
Pressing a title switches between ascending and
descending order each time you press the title, and
[v] (ascending) or [V] (descending) is displayed on
the right side of the title.
Box Slot/Port: Sort by slot number/port number
Strm Sts./Name: Sort by video stream (ST 2110)
transmission status and output name
4
Enable/disable the video/audio/metastreams (ST
2110) using the [Stream Stop/Start] switch.
On: Output video stream (ST 2110).
Off: Do not output video stream (ST 2110).
5
Set the multicast primary address and port number.
[Primary Address] button: Multicast primary
address
[Port] button: Multicast primary port number
To set consecutive addresses, select multiple buttons
and enter an address.
Consecutive addresses starting from the entered
number are configured.
Note
When consecutive multiple buttons are selected and
consecutive addresses are configured, the maximum
value of the set range will be duplicated if the
configuration range is exceeded.
6
Set the multicast secondary address and port number.
[Primary Address] button: Multicast secondary
address
[Port] button: Multicast secondary port number
382
Advertisement
Table of Contents
