Remote Syslog - Planet WGS-5225-8P2SV User Manual

4.2.1.13 Remote Syslog

Configure remote syslog on this page. The Remote Syslog screen in
The page includes the following fields:
Object
 Mode
 Syslog Server IP
 Syslog Level
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
Figure 4-2-16: Remote Syslog Page Screenshot
Description
Indicates the server mode operation. When the mode operation is enabled, the syslog
message will send out to syslog server. The syslog protocol is based on UDP
communication and received on UDP port 514 and the syslog server will not send
acknowledgments back to sender since UDP is a connectionless protocol and it does not
provide acknowledgments. The syslog packet will always send out even if the syslog
server does not exist. Possible modes are:

Enabled: Enable remote syslog mode operation.

Disabled: Disable remote syslog mode operation.
Indicates the IPv4 host address of syslog server. If the switch provides DNS feature, it
also can be a host name.
Indicates what kind of message will send to syslog server. Possible modes are:

Error: Send the specific messages which severity code is less or equal than
Error(3).

Warning: Send the specific messages whose severity code is less or equal than
Warning(4).

Notice: Send the specific messages whose severity code is less or equal than
Notice(5).

Informational: Send the specific messages whose severity code is less or equal
than Informational(6).
70
User's Manual of WGS-5225-8P2S Series
Figure 4-2-16 appears.