4.3.8.2 MVRP Global Configuration
This page allows you to configure the
global section and a per-port configuration section.
The following table shows the adjustable settings on this page.
Object
Global State
Managed VLANs
Port
Enabled
MVRP
global and per port settings altogether. The page is divided into a
Figure 4-3-43: MVRP Global Configuration
Description
Enable or disable the
MVRP
protocol globally and at the same time on the switch ports that are MVRP enabled.
This field shows the managed VLANs, i.e. the VLANs that MVRP will operate upon.
By default, only VLANs 1- 4094 are managed, i.e. the entire range as defined in
IEEE802.1Q-2014 for MVRP. However this range can be limited by using a list
syntax where the individual elements are separated by commas. Ranges are
specified with a dash separating the lower and upper bound.
The following example will create VLANs 1, 10, 11, 12, 13, 200, and 300: 1,10-
13,200,300. Spaces are allowed in between the delimiters.
The port number for which the following configuration applies.
Enable or disable the
MVRP
the protocol on the switch port given that MVRP is also globally enabled.
164
User's Manual of WGS-5225-8P2S Series
protocol globally. This will enable or disable the
protocol on this switch port. This will enable or disable