VID for Source
Interface
Address for Source
Interface
Print Numeric
Addresses
Buttons
: Click to run the diagnostics.
: Click to retrieve another content of interest.
This field can be used to force the test to use a specific local VLAN interface as
the source interface. Leave this field empty for automatic selection based on
routing configuration.
Note: You may only specify either the VID or the IP Address for the source
interface.
This field can be used to force the test to use a specific local interface with the
specified IP address as the source interface. The specified IP address must be
configured on a local interface. Leave this field empty for automatic selection
based on routing configuration.
Note: You may only specify either the VID or the IP Address for the source
interface.
By default the traceroute command will print out hop information using a
reverse DNS lookup for the acquired host ip addresses. This may slow down the
display if the DNS information is not available. Selecting this option will prevent
the reverse DNS lookup and force the traceroute command to print numeric IP
addresses instead.
442
User's Manual of WGS-5225-8P2S Series