Planet WSD-800 Quick Installation Manual
Managed ethernet switches
Hide thumbs
Also See for WSD-800:
- User manual (106 pages) ,
- User manual (66 pages) ,
- User manual (66 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Planet WSD-800
Summary of Contents for Planet WSD-800
- Page 1 Managed Ethernet Switches WSD-800 / WGSD-910 / WGSD-1022C WSW-2401A / WGSW-2840 / WGSW-5240 Quick Installation Guide...
- Page 2 Table of Contents 1. Package Content ..................3 2. Terminal Setup .................... 4 3. Logon to the Console ................... 5 4. Configure IP address ..................7 5. Start Web Management ................8...
-
Page 3: Package Content
1. Package Content Thank you for purchasing the Planet Layer 2 Managed Switch. In the following section, the term “Switch” means the Layer 2 Managed Switch. The PLANET Layer 2 Managed Switch comes with one of the following models. ● WSD-800: 8-Port 10/100Mbps Managed Ethernet Switch ●... -
Page 4: Terminal Setup
2. Terminal Setup To configure the system, connect a serial cable to a COM port on a PC or notebook computer and to serial (console) port of the Switch. The console port of the Switch is DCE already, so that you can connect the console port directly through PC without the need of Null Modem. -
Page 5: Logon To The Console
3. Logon to the Console Once the hardware connection and the terminal program are ready, power on the Switch. The terminal program will display the testing procedures of the Switch and show in Figure 3-1. Figure 3-1 Testing Procedure Screen of the Switch After boot up is complete, the “switch>”... - Page 6 The prompt then change to the “switch\enable>”, please enter “?” to list the commands it offers. As show in Figure 3-3. Figure 3-3 List commands 1. For security reason, please change and memorize the new pass- word after this first setup. 2.
-
Page 7: Configure Ip Address
4. Configure IP address The default IP address of the Switch is “192.168.0.100”. If you want to change the IP address, for example, change the IP address to “192.168.99.234” with subnet mask. “255.255.255.0”, please enter the command: set system ip 192.168.99.234 255.255.255.0 As show in Figure 4-1. -
Page 8: Start Web Management
5. Start Web Management The Switch can be fully managed by console. It also provides a convenient Web management interface for remote management. This chapter guides the quick access to the Web Management Interface of the Switch. Since Web Management Interface can be accessed by Ethernet connection, the administrator workstation must be in the same IP segment as the Switch.