Table of Contents
Advertisement
The scenario is described as follows:
Untagged packet entering VLAN 2
While [PC-1] transmit an untagged packet enters Port 1, the Industrial Managed Switch will tag it with
1.
a VLAN Tag=2. [PC-2] and [PC-3] will received the packet through Port 2 and Port 3.
[PC-4],[PC-5] and [PC-6] received no packet.
2.
While the packet leaves Port 2, it will be stripped away it tag becoming an untagged packet.
3.
While the packet leaves Port 3, it will keep as a tagged packet with VLAN Tag=2.
4.
Tagged packet entering VLAN 2
While [PC-3] transmit a tagged packet with VLAN Tag=2 enters Port 3, [PC-1] and [PC-2] will receive
1.
the packet through Port 1 and Port 2.
While the packet leaves Port 1 and Port 2, it will be stripped away it tag becoming an untagged packet.
2.
Untagged packet entering VLAN 3
While [PC-4] transmit an untagged packet enters Port 4, the switch will tag it with a VLAN Tag=3. [PC-
1.
5] and [PC-6] will received the packet through Port 5 and Port 6.
While the packet leaves Port 5, it will be stripped away it tag becoming an untagged packet.
2.
While the packet leaves Port 6, it will keep as a tagged packet with VLAN Tag=3.
3.
For this example, VLAN Group 1 is set as default VLAN, but only focuses on VLAN 2 and VLAN 3
traffic flow
Setup steps
Add VLAN Group
1.
Add two VLANs – VLAN 2 and VLAN 3
Type 1-3 in Allowed Access VLANs column, the 1-3 is including VLAN1 and 2 and 3.
Figure 4-3-24: Add VLAN 2 and VLAN 3
147
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
