This UI of ERPS is only applied to switches installed with firmware after v1.2112bxxxxxx
The Ethernet Ring Protection Switch instances are configured here; screen in
The page includes the following fields:
Object
ERPS #
Version
Type
VC
Interconnect Instance
Interconnect Prop
Ring Id
Node Id
Level
Control VLAN
Figure 4-6-6: Ethernet Ring Protocol Switch page screenshot
Description
The ID of ERPS. Valid range 1 - 64.
ERPS protocol version. v1 and v2 are supported.
Type of ring. Possible values:
Major: ERPS major ring (G.8001-2016, clause 3.2.39)
Sub: ERPS sub-ring (G.8001-2016, clause 3.2.66)
InterSub: ERPS sub-ring on an interconnection node (G.8001-2016, clause
3.2.66)
Controls whether to use a Virtual Channel with a sub-ring.
For a sub-ring on an interconnection node, this must reference the instance ID
of the ring to which this sub-ring is connected.
Controls whether the ring referenced by Interconnect Instance shall propagate
R-APS flush PDUs whenever this sub-ring's topology changes.
The Ring ID is used - along with the control VLAN - to identify R-APS PDUs as
belonging to a particular ring.
The Node ID is used inside the R-APS specific PDU to uniquely identify this
node (switch) on the ring.
MD/MEG Level of R-APS PDUs we transmit.
The VLAN on which R-APS PDUs are transmitted and received on the ring
ports.
User's Manual of WGS-5225-8P2S Series
Figure 4-6-6
392
appears.