Table of Contents
Advertisement
Instance Command:
Object
Command
Port
Instance State:
Object
Protection State
Port 0
Port 1
Transmit APS
Port 0 Receive APS
Port 1 Receive APS
WTR Remaining
RPL Un-blocked
No APS Received
Port 0 Block Status
Port 1 Block Status
FOP Alarm
Buttons
: Click to save changes.
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 6 seconds.
: Click to refresh the page immediately.
:
Click to undo any changes made locally and revert to previously saved values.
Description
Administrative command. A port can be administratively configured to be in
either manual switch or forced switch state.
Port selection - Port0 or Port1 of the protection Group on which the command is
applied.
Description
ERPS state according to State Transition Tables in G.8032.
OK: State of East port is ok
SF: State of East port is Signal Fail
OK: State of West port is ok
SF: State of West port is Signal Fail
The transmitted APS according to State Transition Tables in G.8032.
The received APS on Port 0 according to State Transition Tables in G.8032.
The received APS on Port 1 according to State Transition Tables in G.8032.
Remaining WTR timeout in milliseconds.
APS is received on the working flow.
RAPS PDU is not received from the other end.
Block status for Port 0 (Both traffic and R-APS block status). R-APS channel is
never blocked on sub-rings without virtual channel.
Block status for Port 1 (Both traffic and R-APS block status). R-APS channel is
never blocked on sub-rings without virtual channel.
Failure of Protocol Defect(FOP) status. If FOP is detected, red LED glows; else
green LED glows.
391
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
