4.6.3 ERPS Status
This page allows the user to configure the ERPS by wizard; screen in
The page includes the following fields:
Object
ERPS #
Oper
Warning
State
TxRapsActive
cFOPTo
UpdateTimeSecs
Request
Version
Rb
Dnf
Bpr
Node Id
SMAC
Buttons
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 6 seconds.
: Click to refresh the page immediately
Figure 4-6-7: ERPS status page screenshot
Description
The ID of the ERPS. Click on link to get to ERPS detailed instance page, you
can reset counters and issue commands
The operational state of ERPS instance.
: Active.
: Disabled or Internal error.
Operational warnings of ERPS instance.
: No warnings.
: There are warnings, use tooltip to see.
Specifies protection/node state of ERPS.
Specifies whether we are currently supposed to be transmitting R-APS PDUs on
our ring ports.
Failure of Protocol - R-APS Rx Time Out.
Time in seconds since boot that this structure was last updated.
Request/state according to G.8032.
Version of received/used R-APS Protocol. 0 means v1, 1 means v2, etc.
RB (RPL blocked) bit of R-APS info. See Figure 10-3 of G.8032.
DNF (Do Not Flush) bit of R-APS info. See Figure 10-3 of G.8032."
BPR (Blocked Port Reference) of R-APS info. See Figure 10-3 of G.8032.
Node ID of this request.
The Source MAC address used in the request/state.
394
User's Manual of WGS-5225-8P2S Series
Figure 4-6-7
appears.