Canon NP6012 Service Manual page 184

MI MECHANICAL SYSTEM
Jamp heater may. be hot.
"Wait about 5 to 6 min after disconnect-
ing the power plug. _
Before Work
» Adhesive Tape
1) Disconnect the power plug.
2) Cut the adhesive tape to about 50 x 50
mm; prepare two strips.
3) Remove the top cover.
4) Remove the copyboard glass.
5) Remove the scanning lamp.
6) Remove the screw (, and remove the
heater plate @.
The scanning lamp heate
either 115 V or 220/240
.
select the one that suits th
vollagerating, = =
To identify, refer to the color of the.
cable and the rating marked
on the
connector; if blue, for 115 V; i f blac
for 220/240 V.
ay
Figure 4-408
7) Disengage the rear @ and the front @ of
the scanning cable from the hook ©;
then, fix it in place while keeping the
wire tension loose using the strips of
adhesive tape ©.
Figure 4-409