Canon NP6012 Service Manual page 182

WB MECHANICAL SYSTEM
Install the scanning lamp so that the
" a
light-emitting portion (transparent glass) is
A. IHuminating Assembly
on the left when viewed from the front of the
copier.
1. Removing the Scanning Lamp
1) Disconnect the power plug. Light-emitting portion
2) Remove the top cover.
3) Remove the copyboard glass.
4) Hook fingers on both ends of the scan-
ning lamp @, and remove the lamp
while rotating it.
Figure 4-402 (front view)
1) Remove the two screws @, and remove
the multifeeder unit @.
1)
Figure 4-401
Figure 4-403
2) Turn the flywheel © of the scanner
motor, and move the No. 4 mirror mount
@ so that it is nearly at the center.
Figure 4-404