Table of Contents
Advertisement
3. Scanner drive wire attachment proce-
7) Remove the four screws @ and the lens
dure
cover ©).
[1] Preparation
Prepare the following tools beforehand.
* Mirror positioning tool (FY9-3009)
* Wire clip (FY9-3017)
« Adhesive tape
1) Set the mirror positioning tool.
Figure 4-211
Figure 4-209
2) Prepare about five sheets of adhesive
tape which are cut in approximately
20mm x 50mm size.
3) Remove the copyboard cover.
4) Remove the upper cover.
5) Remove the copyboard glass.
6)
Remove the sensor cable @ and three
screws
@ and remove the cross mem-
ber @).
Figure 4-210
4-8
COPYRIGHT © 1995 CANONINC.
CANON NP6O12/NP6OI2F /NPG212 REV.1 SEPT, 1995 PRINTED IN JAPAN (IMPRIME
AU JAPCN)
Advertisement
Chapters
Table of Contents
