Table of Contents
Advertisement
——————LLLL€<€<€kLL
SESE
EES
SSS
OP NATIONS AND TIMING Ee
4) Press the Copy Start key to make a
7) Press the push switch (PSW) on the
copy.
ADF controller PCB.
5) Check to make sure that he distance L4
* The copy paper will be picked up from
on the copy image indicated is 10 +2.0, -
the original tray and stopped on the
2.5 mm (standard) or less.
copyboard glass.
PSW
04
ire
Copy image
€ 4=1042.0mm
Figure 3-818
6) If the distance is not as specified, shift
Figure 3-820
bit 1 of the DIP switch (SW1) on the
ADF controller PCB to ON, and place an
8) Use the rotary switch (SW2) on the ADF
A4 or LTR white copy paper on the origi-
controller PCB to adjust the original
nal tray.
leading edge stop position.
Moving the rotary switch by a single
notch changes the original stop position
by about 0.3 mm.
Press the push switch
(PSW)
after
deciding on a position to discharge the
copy paper and store the optimum
value.
Figure 3-819
Figure 3-821
COPYRIGHT © 1995 CANON INC,
CANON NP6O12/NP6OL2F/MP6212 REV.1 SEPT. 1995 PRINTED
IN JAPAN ((NPRIME AU JAPON)
3-91
Advertisement
Chapters
Table of Contents
