SSS
SS
MECHANICAL SYSTEM
8) After hooking the longer side of the wire
[3] Attaching forward wire
@ on the wire hook (8, use adhesive
1) Wind the forward wire (black) @ on the
tape ( to secure the rear end of the
wire on the left side face. Arrange the
securing position of the wire so that the
rear end of the wire comes to the posi-
tion as shown
in the Figure below
upper side hook @ wire drive pulley 1.5
times so that the longer side comes to
the top, then, secure the shorter side of
the wire @ as shown in the figure below
using adhesive tape @).
against the hole on the left side face.
Face with-
W
6,
*
0)
Figure 4-221
2) Route the longer side of wire © along
the wire drive pulley and hook it on the
pulley © at the right hand front side as
shown in the figure below.
Figure 4-220
Figure 4-222
COPYRIGHT © 1995 CANON INC.
CANON NPSO12/NPGOI2F/NP62(2 REV.1 SEPT. 1995 PRINTED IN JAPAN (MPRIME
AU JAPCN)
4-11