Canon NP6012 Service Manual page 160

ll MECHANICAL SYSTEM
4-10
through under mirror 1 mount @) and the
mirror 2 and 3 mount @), then hook it on
the pulley (0 at the left rear side and pul-
ley @ of the mirror 2 and 3 mount.
Figure 4-216
5) After hooking the shorter side of the wire
© on the wire hook @, use adhesive
tape 43 to secure the rear end of the
wire on the left side face. Arrange the
securing position of the wire so that, as
shown in the Figure below, the rear end
of the wire comes to the position against
the hole on the Jeft side face.
Figure 4-217
COPYRIGHT © 1995 CANON RIC,
the pulley 45 at the right hand front side
as shown in the Figure below by routing
it along the wire drive pulley @.
7)
Figure 4-218
Put the longer side of the wire 4
throught under mirror 1 mount @) and
mirror 2 and 3 mount ©), then hook it on
the pulley (@ at the left hand front side
and pulley @ of mirror 2 and 3 mount.
Figure 4-219
CANON NP6012/NP6012F /NPG212 REV.1 SEPT, 1995 PRINTED N JAPAN (IMPRIME AU JAPON)