Table of Contents
Advertisement
SSS
SSS
a
MECHANICAL SYSTEMIC
When installing the multifeeder unit, go
through the following steps:
1) Turn on the power switch, and
select multifeeder mode; then,
press the Copy Start key.
2) When the pick-up gear unit has
risen to its topmost position, turn
off the power switch.
3) After installing the multifeeder unit,
select multiteeder mode and make
one copy.
Removing the Pick-Up Roller
Remove the pick-up roller unit. (See "1.
Cassette Pick-Up Roller Unit.")
Remove the stop ring (plastic) (@, and
pull out the pick-up roller.
COPYRIGHT © 1995 CANON INC.
Take care not to lose the pin at the
rear,
Caution:
Figure 4-306
Removing the Pick-Up Clutch
Remove the top cover. (See "Removing
the Top Cover.")
Remove
the front lower cover. (See
"Removing the Front Lower Cover.")
The on unit will i upenen keep a
hand
on the top while opening it. _
lf the copier came with an ADF as stan-
dard, open the upper frame unit, and
remove the two screws @) to remove the
sub hinge mount @.
4)
Figure 4-307
If the copier came with an ADF as stan-
dard, remove the spring @).
CANON NP6O12/NPGO12F /NP6212 AEV.1 SEPT. 1995 PRINTED IN JAPAN (IMPRIME AU JAPON}
Figure 4-308
4-23
Advertisement
Chapters
Table of Contents
