Table of Contents
Advertisement
Bi OPERATIONS AND T1241 GS
G. Reproduction Ratio Fine
Adjustment
Use this mode after replacing the follow-
ing:
* DC controller PCB
Operation
1) Select '36' in service mode; and using
the +/- key, enter the setting under
'LENS_ADJ'
on the service label, and
press the AE'key.
H. Pre-Exposure Lamp Output
Adjustment
Use this mode after replacing the follow-
ing:
¢ DC controller PCB
¢ Pre-exposure lamp
Operation
e
After Replacing the DC Controller PCB
1) Select '37' in service mode; and using
the +/- key, enter the setting under
'PREX_LP'
recorded on the service
label, and press the AE key.
e
After Replacing the Pre-Exposure Lamp
1) Select '37' in service mode; using the +/-
key, enter the setting recorded on the
label on the pre-exposure
lamp you
have replaced, and press the AE key.
2) Record the setting you have entered
under 'PREX_LP' on the service label.
3-100
COPYRIGHT © 1995 CANONINC,
CANON NP6O12/NPGOT2F /NP6212 REV.1 SEPT. 1995 PRINTED IN JAPAN (IMPRIME AU! JAPON)
Advertisement
Chapters
Table of Contents
