Juniper ACX1000 Hardware Manual page 114

NOTE: Each power supply must be connected to a dedicated AC power feed and a dedicated
customer site circuit breaker. We recommend that you use a dedicated customer site circuit
breaker rated for 2 A (100 VAC) or 1 A (240 VAC), or as required by local code.
5. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust and
access to router components, or drape where people could trip on it.
6. Repeat Step 1 through Step
7. Observe the system LED on the router. If an AC power supply is functioning normally, the system
LED lights green steadily.
If the system LED is not lit, the power supply is not functioning normally. Repeat the cabling
procedures.
Figure 24: Connecting AC Power to the Router
SEE ALSO
ACX1100 AC Power Specifications | 61
5 for the remaining power supply.
106