Juniper ACX1000 Hardware Manual page 136

CAUTION: Make sure that you open the ejector handle completely until you hear it
click. This action prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
6. Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3 cm) out of
the router.
7. Using your fingers, grasp the body of the transceiver, and pull it the rest of the way out of the router.
Figure 32: Removing Transceivers
8. Place a rubber safety cap over the transceiver.
9. Place the removed transceiver on an antistatic mat or in an electrostatic bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30 seconds
before reinserting it or inserting a transceiver into a different slot.
SEE ALSO
Front Panel of an ACX1000 Router | 48
Uplink Ports on ACX1000 and ACX1100 Routers | 51
128