Serial Matrix Emulation - Printronix P8000 Plus Series Administrator's Manual

Slew Relative
"Slewing" is rapid vertical paper movement. This parameter determines the number of lines slewed (either
1-15 lines or 1-16 lines) when an EVFU Slew Relative command is received. The options include:
•
1-15 Lines
•
1-16 Lines (factory default)

Serial Matrix Emulation

Printer
Protocol
(from page 102)
Serial Matrix
Control Code
06
8.0 LPI* CR = CR*
10.3 LPI CR = CR + LF
6.0 LPI
Alt. Set Character
80-9F
(see page 131)
Control Code*
Printable
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can select an alternate line
spacing of 6, 8, or 10.3 LPI.
Define CR Code
This option controls the action of the printer when it receives a Carriage Return code (hex 0D) from the
host computer. If this feature is enabled, each time the printer receives a Carriage Return, it inserts an
additional Line Feed code (hex 0A) into the data stream. Do not use this feature if the host computer
sends line feeds to the printer.
•
CR = CR (factory default). Does not insert an extra line feed after each carriage return.
•
CR = CR + LF. Inserts an extra line feed after each carriage return. The next print position will be
print position 1 of the next line.
Define CR
Autowrap
Code
Wrap LF+CR*
Wrap CR
Disable
ESC d
Set command
Even dot plot*
Double high
*= Factory Default
Define LF
Overstrike
Code
Enable* LF = LF*
Disable LF = CR + LF
Printer
Select
Disable*
Enable
129