Printronix P8000 Plus Series Administrator's Manual page 281

Table 24 LCD Message Troubleshooting Table (H-Series)
Displayed Message
ETHERNET
INITIALIZING
EXCEPTION ERROR
FLASH: CHECK
RETURN
FLASH: WAS
NOT CLEARED
FLASH: WRITE
ERROR # 2
GENERATING XX%
NAND FLASH TABLE
H00: PCI SLOT ?
See User Manual
H01: PCI J12
See User Manual
<Online, etc...>
Half Speed Mode
Can User
Explanation
Correct?
No Status message: the internal
Network Interface Card is
processing the boot
procedure. (May occur with
older versions of microcode.)
No An EXCEPTION
INTERRUPT has occurred.
No Printer encountered an error
while trying to program Flash
memory.
No Printer encountered an error
while trying to program Flash
memory.
No Printer encountered an error
while trying to program Flash
memory.
No
NAND FLASH is being read
and system tables are being
initialized.
No The controller board is not
communicating with a PCI
card. This could indicate a
bad PCI card, poor
connection, or problem in
the PCI bus.
No
The controller board is not
communicating with the PCI
card in PCI slot J12. This
could indicate a bad PCI
card, poor connection, or
problem in the PCI bus.
No Status message: The
controller samples the
operating temperature of key
components of the print
mechanism. When higher
than normal temperatures
are sensed, the print speed
is automatically reduced by
50% and the message sent
the LCD. When the
components cool down, the
print speed returns to 100%
and the message clears.
Solution
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required. If the
message appears often, contact
your authorized service
1
representative.
281