Table of Contents
Advertisement
When the PDF is printed above or below the barcode, the behavior will depend on the Update PDF menu
setting.
•
Embedded Only (factory default). Embedded PDFs will not be replaced. This allows the user to keep
the present PDF data and its font, etc.
•
Always. PDFs will always reprint. For instance, since the original PDF will not be centered with
respect to the replaced barcode, the user may want to always replace the PDF. When set to Always,
an extra 1/6" is erased to remove the original PDF. If the original PDF is not fully erased, it is up to the
user to increase the Ver. Erase Zone setting such that the original PDF will be completely erased
prior to the replacement being printed.
Barcodes on Page
This setting defines the number of barcodes that must be detected on the form. If the value is set to
"Auto" (factory default), no particular number of barcodes are required to be detected. If the value is set to
a number between 1 to 20, then the number of barcodes set is required to be detected on each form. If
the printer detects fewer barcodes than the value set, the fault "x/y BARCODES / Not Found" is declared.
x represents the number of barcodes not found, and y represents the Barcodes on Page value. Printing
will not continue until the user clears this fault.
Bcodes Optimized
This is a display menu that continuously counts the number of barcodes that have been optimized since
power-up. This statistic only resets to zero when the printer is powered off. This menu can be used as a
diagnostic to check the number of barcodes optimized over a period of time or over a batch file.
197
Advertisement
Table of Contents
