Printer Mgmt Menu - Printronix P8000 Plus Series Administrator's Manual

Printer Mgmt
Refer to the Printer Mgmt Menu on page 207.

Printer Mgmt Menu

Printer Mgmt
(from page 204)
PNE Port
Ethernet*
USB
Disable
Serial
PNE Port
This menu selects which port the printer expects PNE to connect to, via Ethernet or USB. The factory
default is Ethernet. If the network is not enabled, the default is Disable.
Mgmt Protocol
Since PXML and UCP management protocols share the same Ethernet Port, only one can be active at a
time. This menu selects the active Management Protocol Interface, either PXML or UCP. The factory
default is PXML.
PNE Port Number
This menu selects the port number the printer expects the PNE to connect through. The factory default is
3001 and the range is from 1025 to 65535.
PNE Port Timeout
If the PNE has not communicated to the printer within a timeout period, the PNE session closes. The
factory default is 100 seconds. The range is from 1 to 255 seconds.
Status Port Numb
This menu selects the port number the printer sends the emulation status. The factory default is 3001 and
the range is from 1025 to 65535.
Mgmt Port Number
This menu selects the port number the printer expects the PXML or UCP to connect through. The factory
default is 3007 and the range is from 1025 to 65535.
Mgmt PNE Port
Protocol Number
UCP 3001*
PXML* 1025 - 65535
*= Factory Default
1
Only available if PNE Port is set to Ethernet
PNE Port
1 1
Timeout
100 Seconds*
1-255 Seconds
Status Port Mgmt Port
Numb Number
3002* 3007*
1025 - 65535 1025 - 65535
207