Table of Contents
Advertisement
Test Width
Set this parameter to run the self-tests at full width or 80 columns.
Phase Value
During the Phasing Test, this value changes until printing is phased. The range is between 1-2000.
Paper Out Dots
CAUTION
Only authorized service representatives should set this parameter.
This parameter is used to adjust the paper out distance from the perforation; you can specify where the
last line on the page will print when there is a paper out condition. Setting this parameter correctly
prevents printing on the platen.
System Memory
Displays the amount of RAM installed.
Print Statistics
You can view various printer statistics and refer to them for preventive maintenance purposes. Printer
statistics accumulate continuously; they do not reset when you turn off the printer. All of the printer
statistics are set to zero at the factory after burn-in testing.
•
On. The cumulative time in hours the printer has been powered on. The range is 0 to 2,386,092
hours.
•
Print. The cumulative time in hours the printer has actually been printing. The range is 0 to 2,386,092
hours.
•
Print Strokes. The cumulative number of back-and-forth shuttle strokes the printer has printed during
normal printer operation. The range is 0 to 2,147,483,647 shuttle strokes.
•
Print Lines. The cumulative number of lines the printer has printed. The range is 0 to 2,147,483,647
print lines.
•
11 inch Pages. The cumulative number of pages the printer has printed. The range in print pages is
0 to 2,147,483,647 total inches of paper movement divided by 11.
•
Poweron Pages. The number of pages the printer has printed since power-up.
Software Build
Displays the part number and version of the printer firmware.
Feature File
Displays the part number of the file if one has been downloaded to the printer.
Shuttle Type
Displays the type of shuttle installed, i.e. 2000s, 1500, 1000, 500, or high definition.
Auto Dump
•
Disable (factory default).
•
Enable. When a printer get 'E03x' type of message on the operator panel, a dump file will be
automatically created and store in flash as file "autodbg1.dbg" or "autodbg2.dbg" in the printer file
system. This file can be uploaded to the host using the PrintNet Enterprise Suite application. Upon
receipt of this file, it should be sent to Printronix Customer Support for review and evaluation.
206
Advertisement
Table of Contents
