Printronix P8000 Plus Series Administrator's Manual page 200

•
Copy From SD. Copies selected files from the SD card (root directory) to the Main File System.
•
Print File List. Prints a summary of the files stored on the SD card (root directory) and several
statistics on the SD File System usage.
•
Update QCMC. This menu can be used to update the configuration within the QCMC image stored
on the SD card (see Appendix D, Quick Change Memory Card (QCMC).
•
Erase QCMC. This menu can be used to erase the QCMC image stored on the SD card (see
Appendix D, Quick Change Memory Card (QCMC).
Set Sharing
This option allows character sets to be shared between the active LP+ protocol and the active IGP
emulation.
Changing characters sets in LP+ causes the active IGP to change to the same character set if the
selected set exists in IGP. If the active IGP has no access to the selected set, no changes are made.
Selecting a new character set in the active IGP causes the LP+ to change to the same character set if the
selected character set exists in the active LP+ protocol. Not all sets are shared between emulations in the
Standard group of character sets. As a result, selecting a set in the Standard group of LP+ or IGP
emulation may or may not cause the other emulation to have the same set.
NOTE: The Set Sharing front panel option has no effect on the LP+ build.
The option only applies to the builds with IGP.
This option is not available in the PCL-II or LG emulation.
Shuttle Timeout
The amount of time the shuttle continues moving after no data is received. If your host is slow, setting the
number to a higher value will prevent the printer from spending time shuttling up and down between data
bursts.
Slow Paper Slew
•
Disable (factory default). The paper will slew and stack paper at maximum speed.
•
Enable. Causes the paper to stack at a slower rate. This ensures that certain forms will stack neatly.
Alarm
•
On (factory default). An audible alarm sounds (3 beeps) when a fault occurs, such as a paper jam.
•
Cont. Beep. A continuous audible alarm sounds when a fault occurs, which can be stopped by
pressing CLEAR.
•
Off. No audible alarm will sound.
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time before the printer goes into
Power Saver mode. When Instant is chosen, the printer goes into Power Saver mode as soon as it is able
to stop the shuttle properly. The time allotted to perform this function depends upon the shuttle timeout
value which can be set in the menu.
NOTE: Power Saver Mode will not be shown on the control panel even though the function still exists.
Sending a print job to the printer will turn off Power Saver mode.
200