Printronix P8000 Plus Series Administrator's Manual page 312

PTX_SETUP commands have the following format:
(SFCC)PTX_SETUP
Command–Sub Command;Value
PTX_END
For example, if the SFCC assigned to PTX_SETUP is the default value of the exclamation mark (!, hex
21), and you wanted to load configuration number 4 and capture all incoming data to a file named "BIN",
you would use the following command:
!PTX_SETUP
CONFIG–LOAD;4 FILE_IO–CAPTURE;BIN
PTX_END
Table 27 lists all the command, sub-command, and parameter combinations and gives a brief description
of the command. This section documents the existence of PTX_SETUP commands which work across all
platforms. The following sections document commands which are specific to line matrix.
NOTE: When a file system error occurs, a message will be displayed on the front panel indicating the
error, and the action needed to take to correct the error.
Table 27 PTX_SETUP Commands (Non-Platform Specific)
Command
CONFIG
312
Sub-Command
LOAD
SAVE
SETMENU
POWERUP
PRINT
Parameter
Cfg Cfg can be 0-8. The PTX_SETUP
will load configuration Cfg. If
configuration Cfg was not previously
saved, the operator panel will display
an error message and the current
configuration will be kept.
Cfg Cfg must be 1-8. This command
will save the current configuration
as configuration Cfg. If Cfg is not in
the range of 1-8, the command is
ignored.
Value;Menu_tag
Menu_tag is the name of the menu
as defined in the menu file. Value is
the value to which the menu is to be
set.
Cfg Sets the power-up configuration
to Cfg and loads Configuration
Cfg. Cfg can be any value from 0-
8, where 0 is the factory default.
Cfg Print Configuration Cfg. Cfg can be
a number 1-8, or one of four pre-
defined configurations. The four
non-numeric configurations are
requested using the first character
for the CURRENT, FACTORY,
POWERUP, or ALL configuration(s).
Description