Table of Contents
Advertisement
9. Turn the platen stop knob clockwise or counterclockwise to match the paper thickness. (The 1-2-3
scale corresponds approximately to 1-, 3-, and 6-part paper thickness).
NOTE: If you are using the same thickness of paper, there is no need to readjust.
10. Lower the platen lever until it stops.
11. Press ONLINE to remove the "LOAD PAPER" fault message from the display.
12. Press ADVANCE several times to make sure the paper feeds properly beyond the tractors and over
the lower paper guide. Feed sufficient paper to ensure the paper stacks correctly.
13. Close the printer top cover. Close the cabinet front door.
14. Press ONLINE to place the printer in online mode and resume printing.
NOTE: Perform steps 15 to 31 only if you are unable to load the new paper over the existing paper.
15. Open both tractor doors.
16. Remove the old paper from the tractors. Allow the paper to fall into the paper supply area.
17. Feed the new paper up through the paper slot. Hold the paper to prevent it from slipping down
through the paper slot (see Figure 6 on page 28).
30
Vertical Position
Knob
A
Platen Stop
Platen Lever
Figure 8 Setting the Platen Lever
Paper Thickness
Indicator
A
Platen Stop
Knob
Advertisement
Table of Contents
