Table of Contents
Advertisement
Define CR Code
This option controls the action of the printer when it receives a Carriage Return code (hex 0D) from the
host computer. If this feature is enabled, each time the printer receives a Carriage Return, it inserts an
additional Line Feed code (hex 0A) into the data stream. Do not use this feature if the host computer
sends line feeds to the printer.
•
CR = CR (factory default). Does not insert an extra line feed after each carriage return.
•
CR = CR + LF. Inserts an extra line feed after each carriage return.
Autowrap LF
This option defines the printer action when print data is received past the forms width setting.
•
With LF+CR (factory default). Performs an automatic carriage return and line feed when data is
received past the forms width.
•
With CR. Performs an automatic carriage return (without line feed) when data is received past the
forms width.
•
Disable. Discards any data past the forms width.
Define LF Code
•
LF = LF (factory default). Does not perform an automatic carriage return when a Line Feed command
is received. The next print position will be the current print position of the next line.
•
LF = CR + LF. Forces an automatic carriage return with each Line Feed command received. The next
print position is print position 1 of the next line.
FF Valid at TOF
•
Enable (factory default). Performs a form feed when the host sends a Form Feed command and the
printer is at the top of form.
•
Disable. Will not perform a form feed when the host sends a Form Feed command and the printer is
at the top of form.
Character Set
Specifies a character set as shown in Proprinter XL Character Sets Menu on page 134. To use one of
these sets, choose the desired group heading (such as European Sets) and press ENTER. Then choose
the desired set within that group (such as Roman 8) and press ENTER. Both the group and the desired
set will be starred to indicate your selection. The UTF-8 selection allows printing of UTF-8 encoded
Unicode ™. Character sets are shown in detail in the Character Sets Reference Manual.
Alt. Char Set
This option determines if data in the range of hex 80 through hex 9F should be interpreted as a control
code or as a printable character.
•
Set 1 (factory default). Interprets data in the range of hex 80 through hex 9F as a control code.
•
Set 2. Prints data for the characters at hex locations 03, 04, 05, 06, 15, and 80 through 9F.
20 CPI Condensed
Compressed print characters are narrower than the normal character set. This is helpful for applications
where you need to print the maximum amount of information on a page.
•
Enable (factory default). Prints characters about 60 percent the width of normal characters when
compressed print is chosen by the host computer.
•
Disable. Does not compress print widths, even if condensed print is chosen by the host.
133
Advertisement
Table of Contents
