Printronix P8000 Plus Series Administrator's Manual page 313

Table 27 PTX_SETUP Commands (Non-Platform Specific)
Command Sub-Command
CONFIG DELETE
UPLOAD
DOWNLOAD
OVERLAY
RESET
GET_NAMES
SET_NAME
CLEAR_NAMES
MPI_SELECT
PNE_PORT
Parameter
Cfg
Deletes Configuration number Cfg.
Cfg must be in the range of 1-8.
Port;Cfg This command uploads the
configuration stored in location Cfg
to the port specified by Port. Port
must either be 1284 or SERIAL.
Cfg may be 1-8 or ALL.
Cfg This command saves the
configuration data that follows as
configuration Cfg. Cfg must be 1-
8 or END.
Cfg This command overlays the
configuration data that follows on
existing configuration Cfg. Cfg must
be 1-8 (or END). If Cfg does not
exist then command is treated the
same as DOWNLOAD.
Reboots the printer.
"Port" This command uploads the names
of the configurations to the port
specified by Port. Port must either
be "1284" or "SERIAL".
Cfg
This command downloads a name
for the configuration specified by
Cfg. Cfg must be 1-8.
This command resets all of the
configuration names to their default
values.
MPI This command selects the active
Management Protocol Interface
(MPI). Currently there are two
selections "UCP" and "PXML".
Port
This command selects the port that
the PNE will use to communicate to
the printer.
The valid ports are:
•
•
•
NOTE: If ETHERNET is selected
but not enabled, the selection will
revert to DISABLE.
Description
DISABLE
ETHERNET
USB
313